ProteX Core Hole Sealing
Available, delivery time: 1-3 working days
Product number:
4-015-S22004
| Priming of core-drillings and sealing with special paint |
| Description | Container of primer and container of special paint |
| Please consider also the publications of the german institution "Berufsgenossenschaft der Bauwirtschaft (BG Bau)" regarding the handling of epoxy resins. |
Features
Short drying time Two-component epoxy resin Fully-hardened, white protective coating has a smooth, viscoelastic surface and is insensitive to shocks and impacts The treated surface has a very good resistance to alkalis and acids and is seawater proofAreas of application
Especially for sealing the concrete of a core hole The coating is suitable for indoor and outdoor use as a non-porous protective coating for concrete, fiber cement, masonry, steel, wood and other materials.Description
The resincan be used at ambient temperature of 5 °C upwards. The surface to be coated must be cleaned and carefully driedby preheating the surface, smooth surfaces need to be roughened beforehand with emery cloth grain size 60 or coarser, the abrasive dust is to be removed afterwards. The hardener is added to the can with the liquid plastic and stirred well. The application is done with the brush included in the delivery. The layer thickness is approx. 0.25 mm per coat, up to three coats can be applied if required.Assembly Instructions
| 1 | The surface to be coated must be cleaned and dried thoroughly using surface pre-heating. Smooth surfaces should be roughened beforehand with emery cloth, 60 grit or coarser. The grinding dust must be removed afterwards |
| 2 | The system can be used at ambient temperatures ranging from +5°C to +30°C. The contents of the container must be stirred well before use, then applied to the surface with a brush, covering evenly. After application of the primer and a flash-off time of approx. 1 hour at room temperature, the coating can be applied. The layer thickness of the special finishing paint is about 0.1 mm per coat – up to three layers may be applied, as required |
| 3 | At an ambient temperature of 20°C, a drying time of at least 12 hours is required before the seal is installed. Higher temperatures accelerate the drying time (up to max. 5 |
| Attention | When working with the product, safety glasses with side protection and protective gloves are to be worn. Closed working clothes are recommended. Keep away from sources of ignition. In case of insufficient ventilation, use suitable respiratory equipment. |
|
PSI Products GmbH
Ulrichstrasse 25
72116 Mössingen
Telefon: 0 049 (0)7473 37 81 0
E-Mail: vertrieb@psi-products.de