EndiT KG/KO Casing End Seal
Product number:
3-013-03000
| Ending of pipe-in-pipe systems for new installations or retrofitting; requirement for a dirt- and moisture-protected sealing solution; suitable for almost all combinations of carrier and casing pipes. Available in oil and gas resistant material, as well as for high temperatures |
| Description | fastening straps stainless steel |
| Material type | Neoprene rubber |
| Shore hardness | Shore A 65 ° ±5 |
| Rubber thickness | 2 bis 3 mm |
| Color | black |
| Description | Individual production according to customer requirements suitable for eccentric positioned carrier pipes flexible adjustment of end seal on site no additional tools necessary KG for new installations KO for retrofitting closing by means of applied adhesive stripe high resistances depending on material quality |
| Casing end seals are available for new installations, and for retrofitting. |
| Medium pipe (nominal diameter ND) | 25 |
|---|---|
| Protection pipe (nominal diameter ND) | 40 |
| Versions | KG - closed |
Features
Protection against moisture and dirt Also suitable for retrofitting Individual or special solutions possibleAreas of application
Pipes carrying media (e.g. gas pipeline, water pipeline, sewage pipeline, etc.) below motorways, main roads, railway tracks, etc. are often laid in casing pipes, here they are used as protective pipe closures.Description
The end seals are used to seal the annular space between the carrier pipe and the casing pipe against dirt and moisture.Assembly Instructions
| 1 | Remove the protective foil from both adhesive surfaces. |
| 2 | Place the KO sleeve around the carrier pipe. Put the adhesive surfaces on top of each other. Press the seam with high pressure for approx. 5 minutes. |
| 3 | Pull the large end of the sleeve onto the casing pipe. Fold in the sleeve and secure the ends with stainless steel straps. |
| ! | If the sleeve diameter is too small for the carrier pipe, the KG or KO sleeve can be cut off on site with scissors (20 mm result in a Ø increase of about 13 mm to 20 mm). In doing so, make sure that the sleeve is 2-5 % smaller than the outer pipe diameter in the area of the carrier pipe so that the sleeve adheres crease free |
|
PSI Products GmbH
Ulrichstrasse 25
72116 Mössingen
Telefon: 0 049 (0)7473 37 81 0
E-Mail: vertrieb@psi-products.de